No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S9300, S9300E, and S9300X Series Switches Hardware Installation and Component Replacement

This document describes hardware installation procedures of the S9300, S9300E, and S9300X series switches, troubleshooting methods for common hardware faults, and switch maintenance instructions.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Safety Precautions

Safety Precautions

Before you start the installation procedure, read all safety precautions described in this document and observe any warning labels affixed to the switch. Doing so ensures your safety and protects the switch from damage.

Safety precautions provided in this document may not cover every eventuality, so remain mindful of safety at all times.

Only trained and qualified personnel should be allowed to install, operate or maintain the equipment.

General Safety

Always take precautions against ESD whenever you handle a switch. For example, wear ESD gloves or an ESD wrist strap. To avoid electric shock or burn, remove conductive objects like jewelry and watch.

Connect the ground cable first after installing the switch into a cabinet or rack. Do not remove the ground cable unless all the other cables and modules have been removed from the chassis.

Environmental Safety

Install the switch in an environment free of flammable or explosive gases or smoke.

Install the switch in a dry environment away from sources of water.

The installation site must be well ventilated to prevent the switches from overheating.

Electrical Safety

Contact with high-voltage power can be fatal. Never touch uninsulated electrical wires or terminals that have not been disconnected from their power source.

Never install or remove the switch or power cables while the power is on.

To ensure personal and equipment safety, ground the switch before powering it on.

Laser Safety

Never look directly into an optical module or the ends of optical fibers. Optical modules and connected fibers emit laser radiation that can cause eye damage.

Cover fiber connectors with dust caps when they are not connected.

Mechanical Safety

Wear protective gloves when you are moving the chassis.

Use safe lifting practices when moving the switch. Never attempt to lift objects that are too heavy for one person to handle. Instead, seek help or use appropriate tools.

Before installing the switch into or removing it from a cabinet, ensure there are no objects that could fall from the cabinet and cause injury.

Do not drill unapproved holes into a cabinet, as doing so may impair its electromagnetic shielding and damage cables inside. In addition, drilling holes produces metal shavings that may enter the cabinet and cause short circuits on printed circuit boards (PCBs).

Updated: 2019-11-30

Document ID: EDOC1000069582

Views: 28294

Downloads: 463

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next