No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X Series Switches Hardware Installation and Maintenance Guide

This document describes hardware installation procedures of the S9300, S9300E, and S9300X series switches, troubleshooting methods for common hardware faults, and switch maintenance instructions.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Unpacking a Crate

Unpacking a Crate

Context

Crates are used to package goods such as cabinets and S9310&S9310X&S9312&S9312E switches. A crate is secured with steel locking bars and has foam materials in it to protect the product. When equipment is delivered, unpack the crate and check the equipment and accessories in the crate.

  • Do not turn a crate upside down; otherwise, the equipment in the crate will be damaged.
  • Wear gloves or take other protection measures to prevent hand injuries when unpacking a crate.
NOTE:

Before unpacking a crate, move it to or close to the installation site (equipment room for example). Do not transport the unpacked equipment over a long distance.

Tools

  • Flat-head screwdriver
  • Needle-nose pliers
  • Protective gloves

Procedure

  1. Inspect the crate. If the crate is delivered upside down, the crate is wet, or the label on the crate is damaged, analyze the cause and contact the equipment supplier immediately. If no exceptions are found, start unpacking the crate.
  2. Raise all the locking bars on the cover of the crate. Insert a flat-head screwdriver (or a claw hammer or a pair of needle-nose pliers) into the hole on a locking bar and raise the flat-head screwdriver to raise the locking bar.

  3. Open the crate cover and remove it.

  4. Raise the locking bars on the side panels of the crate and remove the side panels.

  5. Remove the foam materials, move the equipment out of the crate, and inspect the equipment. If rust or other damage is found on the equipment, analyze the cause and contact the equipment supplier immediately.
Translation
Download
Updated: 2019-05-16

Document ID: EDOC1000069582

Views: 18258

Downloads: 417

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next