No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S9300, S9300E, and S9300X Series Switches Hardware Installation and Maintenance Guide

This document describes hardware installation procedures of the S9300, S9300E, and S9300X series switches, troubleshooting methods for common hardware faults, and switch maintenance instructions.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Ethernet Cables

Connecting Ethernet Cables

Context

NOTE:
  • To connect cables in a cabinet more conveniently, you can remove the side panels of the cabinet before connecting cables.

  • When cables with large diameters are used in an N66E cabinet, there may not be sufficient space for the cables. For example, if Category 6 cables are used on 48-port electrical interface cards in an N66 cabinet, the front door of the cabinet may be unable to close.

Tools and Accessories

  • ESD wrist strap or ESD gloves
  • Phillips screwdriver
  • Diagonal pliers
  • Cable ties
  • Ethernet cable labels
  • Tweezers (delivered with the switch)

Procedure

  1. Determine the number and type of ports to be connected and plan the cabling route.
  2. Select Ethernet cables of appropriate quantity and lengths based on the number of ports and measured cabling distances.
  3. Attach temporary labels on both ends of each Ethernet cable and write numbers on the labels. For details on how to number Ethernet cables, see Engineering Labels for Network Cables.
  4. (Optional) Route Ethernet cables on the planned path. Arrange the Ethernet cables straight, bundle the Ethernet cables (at most 20 cables in a bundle), and route them to a cabinet through the cable tray. Lead the Ethernet cables into the cabinet from the right side.
  5. Wear an ESD wrist strap or a pair of ESD gloves. When wearing an ESD wrist strap, insert the other end in the ESD jack of a device and ensure that the device is reliably grounded.
  6. Connect Ethernet cables to ports of the switch.
    1. (Optional) Find the ports matching the numbers on the Ethernet cables, cut the cables to the required cable length, and crimp connectors on the Ethernet cables.
    2. Plug the Ethernet cable connectors to the matching ports. See Figure 9-18. After verifying that all Ethernet cables are correctly connected, go to step 7.

    Figure 9-18  Connecting Ethernet cables
    NOTE:

    If any Ethernet cable is incorrectly connected, use the tweezers delivered with the switch to remove the cable.

  7. Bundle Ethernet cables. Arrange Ethernet cables, put them through the cable management frames on the corresponding slots, and lead the cables out of the cabinet from the right side of the cabinet. Bundle Ethernet cables with cable ties at intervals of 20 cm to 30 cm. Use diagonal pliers to cut off redundant cable ties.

    When a lot of cables are connected to a card, the cable management frame for this slot may not have sufficient space. In this case, deploy cables in three layers without crossing each other, and then put the three layers through the cable management frame. See Figure 9-19.

    Figure 9-19  Deploying Ethernet cables in three layers

  8. Replace all the temporary labels with permanent labels on the Ethernet cables.

Follow-up Procedure

Use a rope to hang the tweezers in an appropriate place in the cabinet for later use.

Translation
Download
Updated: 2019-05-16

Document ID: EDOC1000069582

Views: 19902

Downloads: 419

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next