27010664 Technical Specifications
Appearance and Structure
Technical Specifications
| Item | Details |
|---|---|
| Part Number | 27010664 |
| Model | SL12432A |
| Description | Directional Antenna,2300-2700/2300-2700MHz,18dBi/18dBi,60deg, +/-45,2deg/2deg,250W/250W,4*N Female,with bracket |
| Frequency [MHz] | 2300 MHz to 2700 MHz |
| Antenna gain [dBi] | 18 dBi |
| Coverage distance [m(ft.)] | The coverage distance is 500 m when the antenna is connected to an AirEngine 6760R-51E, the maximum input power of the AP is 30 dBm, and the RSSI is -70 dBm, regardless of the local EIRP limit. The downlink rate of a single STA is 10 Mbit/s. The coverage distance is 700 m when the antenna is connected to an AirEngine 8760R-X1E, two antennas are used for coverage to form 8x8 MIMO, the maximum input power of the AP is 33 dBm, the RSSI is -70 dBm, regardless of the local EIRP limit. The downlink rate of a single STA is 10 Mbit/s. The STA transmit power must be considered in the coverage distance to avoid insufficient uplink power. |
| Horizontal beamwidth [degrees] | 60 degrees |
| Vertical beamwidth [degrees] | 7 degrees |
| Standing wave ratio (SWR) | ≤ 1.5 |
| Polarization | Cross polarization |
| Attenna connector | N-female x 4 |
| Attenna dimensions [mm(in.)] | 86 mm x 1120 mm x 290 mm (3.39 in. x 44.09 in. x 11.42 in.) |
| Weight without packaging [kg(lb)] | Weight of antenna: 9.9 Weight of mounting bracket: 4.7 |
| Installation type | Pole |
| Grounding requirements | Same as the AP |
| Pole diameter [mm(in.)] | φ50 to φ80 |
| Attenna note | The gains and lobe widths in this document are typical values. The actual values are within a range. For specifications, see the corresponding data sheets. The coverage distance is a reference value in certain conditions. Plan an appropriate distance value according to planning experience, local standards, and onsite environments. There may be differences in the standards of different countries, so the mapping between antennas and APs shall comply with local standards. For details, refer to device access authentication information. The coverage distance is subject to the following constraints: - The default AP transmit power is 15 dBm. - The default STA type is mobile phone, and no obstacle exists. - 2.4 GHz: The uplink and downlink RSSIs are greater than or equal to -70 dBm. For any questions about the parameters above, contact Huawei technical support. |
Antenna's Radiation Pattern
