Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Wall Mounting
The 27012140 antenna can be mounted on a wall.
- The antenna must be installed in a place far away from high-voltage power supplies or radio signal interference sources (such as other APs or antennas).
- Do not install antennas in bad weather conditions, for example, during rain, snow, or strong winds.
- Fix the installation bracket to the back of the antenna with the nut, spring washer, and flat washer.
- Fix the adjustable support to the installation bracket.
Select appropriate holes and thread bolts through the space between the antenna and adjustable support. Place flat washers, spring washers, and nuts to fix them (not tightly).
- Drill four holes (φ8 * 42 mm) on the wall to install plastic expansion tubes that will support expansion bolts. The relative position of the four holes must exactly match with that of the four holes on the antenna support.
- Fix the antenna support to the wall using expansion bolts.
- Fix the adjustable support to the antenna support. Thread bolts through the space between the antenna and adjustable support. Place flat washers, spring washers, and nuts to fix them (not tightly).
- Adjust the antenna angle and tighten all of the four nuts.
