27011016 Technical Specifications
The 27011016 directional antenna is named ASB235G00 and applicable to outdoor scenarios.
Antenna Appearance
Figure 20-1 shows the appearance of the 27011016 antenna.
Technical Specifications
Table 20-1 lists technical specifications of the 27011016 antenna.
Item |
Value |
|---|---|
Frequency (MHz) |
5150–5850 |
Gain (dBi) |
23 |
Coverage distance (m) |
310 |
Horizontal lobe width (degrees) |
9 |
Vertical lobe width (degrees) |
9 |
Standing wave ratio (SWR) |
≤2 |
Polarization |
Cross polarization |
Connector |
N-female*2 |
Dimensions (mm) |
Diameter: φ400 |
Weight (kg) |
3 |
Support pole diameter (mm) |
φ40–φ114 |
Mounting mode |
Pole mounting |
Grounding requirements |
Same as the AP |
- The gains and lobe widths in this document are typical values. The actual values are within a range. For specifications, see the corresponding data sheet.
- There may be differences in the standards of different countries, so the mapping between antennas and APs shall comply with local standards. For details, refer to device access authentication information.
- The coverage distance is subject to the following constraints:
- The default AP transmit power is 15 dBm.
- The default STA type is mobile phone, and no obstacle exists.
- 5 GHz: The uplink and downlink RSSIs are greater than or equal to -75 dBm.
For any questions about the parameters above, contact Huawei technical support.
Antenna Pattern
Figure 20-2 and Figure 20-3 show radiation patterns of the 27011016 antenna in the horizontal and vertical directions.
