Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Wall Mounting
The 27013571 antenna can be mounted on a wall.
- The antenna must be installed in a place far away from high-voltage power supplies or radio signal interference sources (such as other APs or antennas).
- Do not install antennas in bad weather conditions, for example, during rain, snow, or strong winds.
- Install the clamp components.
No.
Name
1
M8 hexagon nut
2
M8 spring washer
3
M8 flat washer
4
M8x20 carriage bolt
Use an S=13 mm wrench to assemble the mounting flange and fastener into an antenna mounting bracket with a reference torque of 188 kgf.cm.
- Drill four φ8 mm holes (70 mm depth) on the wall to install plastic expansion sleeves that will support expansion bolts. The relative position of the four holes must exactly match with that of the four holes on the antenna support.
- Install the antenna on the wall using the antenna mounting bracket.
No.
Name
1
M6 flat washer
2
M6 spring washer
3
M6 hexagon nut
4
M6x80 expansion bolt
Use a wrench (S = 10 mm) with a reference torque of 76 kgf.cm.
- Adjust the angle of the antenna mounting bracket.
