27013921 Technical Specifications
Appearance and Structure
Technical Specifications
| Item | Details |
|---|---|
| Part Number | 27013921 |
| Model | ANT5G15D2NW |
| Description | Directional Antenna-5150~5850MHz-15dBi-45deg/15deg-Nfemale-2ports -with bracket-wall mounting-only used in metro project |
| Frequency [MHz] | 5150 MHz to 5850 MHz |
| Antenna gain [dBi] | 15 dBi |
| Coverage distance [m(ft.)] | The coverage distance is 150 m when the transmit power and field strength of STAs are 15 dBm and -75 dBm, respectively, regardless of the local EIRP limit. |
| Horizontal beamwidth [degrees] | 45 degrees |
| Vertical beamwidth [degrees] | 15 degrees |
| Standing wave ratio (SWR) | ≤ 2 |
| Polarization | ± 45° |
| Attenna connector | N-female x 2 |
| Attenna dimensions [mm(in.)] | 60 mm x 240 mm x 133 mm (2.36 in. x 9.45 in. x 5.24 in.) |
| Weight without packaging [kg(lb)] | Weight of antenna: 0.8 Weight of mounting bracket: 0.6 |
| Installation type | Wall |
| Grounding requirements | Same as the AP |
| Attenna note | The gains and lobe widths in this document are typical values. The actual values are within a range. For specifications, see the corresponding data sheets. The coverage distance is a reference value in certain conditions. Plan an appropriate distance value according to planning experience, local standards, and onsite environments. There may be differences in the standards of different countries, so the mapping between antennas and APs shall comply with local standards. For details, refer to device access authentication information. The coverage distance is subject to the following constraints: - The default AP transmit power is 15 dBm. - The default STA type is mobile phone, and no obstacle exists. - The uplink and downlink RSSIs are greater than or equal to -75 dBm. For any questions about the parameters above, contact Huawei technical support. |
Antenna's Radiation Pattern
