27011333 Technical Specifications
Appearance and Structure
Technical Specifications
| Item | Details |
|---|---|
| Part Number | 27011333 |
| Model | ANT5G05A1NR |
| Description | Omni-directional Antenna,5150~5850MHz,5dBi,360deg/20deg,N/Male,1port,without mounting parts,install directly on AP |
| Frequency [MHz] | 5150 MHz to 5850 MHz |
| Antenna gain [dBi] | 5 dBi |
| Coverage distance [m(ft.)] | 60 m(ft.) |
| Horizontal beamwidth [degrees] | 360 degrees |
| Vertical beamwidth [degrees] | 20 degrees |
| Standing wave ratio (SWR) | ≤ 2 |
| Polarization | Vertical polarization |
| Attenna connector | N-male |
| Attenna dimensions [mm(in.)] | Length: 280±3 |
| Weight without packaging [kg(lb)] | 0.218±0.01 |
| Installation type | Directly installed on the AP |
| Attenna note | The gains and lobe widths in this document are typical values. The actual values are within a range. For specifications, see the corresponding data sheet. The previous specifications list the coverage distance for reference only, which may vary depending on specific conditions. Plan an appropriate distance value according to planning experience, local standards, and onsite environments. There may be differences in the standards of different countries, so the mapping between antennas and APs shall comply with local standards. For details, refer to device access authentication information. The coverage distance is subject to the following constraints: - The default AP transmit power is 15 dBm. - The default STA type is mobile phone, and no obstacle exists. - 5 GHz: The uplink and downlink RSSIs are greater than or equal to -75 dBm. For any questions about the parameters above, contact Huawei technical support. |
Antenna's Radiation Pattern
