27011668 Technical Specifications
The 27011668 omnidirectional antenna is named ANTDG0407A1NR and applicable to outdoor scenarios.
Antenna Appearance
Figure 27-1 shows the appearance of the 27011668 antenna.
Technical Specifications
Table 27-1 lists technical specifications of the 27011668 antenna.
Item |
Value (2.4G) |
Value (5G) |
---|---|---|
Frequency (MHz) |
2400–2500 |
5150–5850 |
Gain (dBi) |
4 |
7 |
Coverage distance (m) |
70 |
70 |
Horizontal lobe width (degrees) |
360 |
360 |
Vertical lobe width (degrees) |
33 |
22 |
Standing wave ratio (SWR) |
≤ 2 |
≤ 2 |
Polarization |
Single polarization |
|
Connector |
N-male |
|
Dimensions (mm) |
Diameter x Length: φ23.8 x 275 |
|
Weight (g) |
106 |
|
Mounting mode |
Connected to APs |
- The gains and lobe widths in this document are typical values. The actual values are within a range. For specifications, see the corresponding data sheet.
- The coverage distance is a reference value in certain conditions. Plan an appropriate distance value according to planning experience, local standards, and onsite environments.
- There may be differences in the standards of different countries, so the mapping between antennas and APs shall comply with local standards. For details, refer to device access authentication information.
- The coverage distance is subject to the following constraints:
- The default AP transmit power is 15 dBm.
- The default STA type is mobile phone, and no obstacle exists.
- 2.4 GHz: The uplink and downlink RSSIs are greater than or equal to -70 dBm.
- 5 GHz: The uplink and downlink RSSIs are greater than or equal to -75 dBm.
For any questions about the parameters above, contact Huawei technical support.
Antenna Pattern
Figure 27-2 shows radiation patterns of the 27011668 antenna in the horizontal and vertical directions.