27012565 Technical Specifications
The 27012565 directional antenna is named ANTDG1211D4NR and applicable to outdoor scenarios.
Antenna Appearance
Figure 38-1 shows the appearance of the 27012565 antenna.
Technical Specifications
Table 38-1 lists technical specifications of the 27012565 antenna.
Item |
Value (2.4G) |
Value (5G) |
|---|---|---|
Frequency (MHz) |
2400–2500 |
5150–5850 |
Gain (dBi) |
12 |
11 |
Coverage radius (m) |
150 |
110 |
Horizontal lobe width (degrees) |
35 |
26 |
Vertical lobe width (degrees) |
35 |
26 |
Standing wave ratio (SWR) |
≤ 2 |
≤ 2.2 |
Polarization |
Cross polarization |
|
Connector |
N-female*4 |
|
Dimensions (mm) |
H x W x D: 40 x 450 x 420 |
|
Weight (kg) |
3 |
|
Support pole diameter (mm) |
φ35–φ114 |
|
Mounting mode |
Wall mounting or pole mounting |
|
Grounding requirements |
Same as the AP |
|
- The gains and lobe widths in this document are typical values. The actual values are within a range. For specifications, see the corresponding data sheet.
- The coverage distance is a reference value in certain conditions. Plan an appropriate distance value according to planning experience, local standards, and onsite environments.
- There may be differences in the standards of different countries, so the mapping between antennas and APs shall comply with local standards. For details, refer to device access authentication information.
- The coverage distance is subject to the following constraints:
- The default AP transmit power is 15 dBm.
- The default STA type is mobile phone, and no obstacle exists.
- 2.4 GHz: The uplink and downlink RSSIs are greater than or equal to -70 dBm.
- 5 GHz: The uplink and downlink RSSIs are greater than or equal to -75 dBm.
For any questions about the parameters above, contact Huawei technical support.
Antenna Pattern
Figure 38-2 and Figure 38-3 show radiation patterns of the 27012565 antenna (2.4 GHz and 5 GHz) in the horizontal and vertical directions.
