Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Wall Mounting
Precautions
Pay attention to the following points when installing this antenna:
- The distance between the installation height and the height of antennas of vehicle-mounted APs is less than 30 cm. It is recommended that it be installed at a position 20 cm higher than the antennas of vehicle-mounted APs.
- The tubular central axis of the antenna is horizontally paralleled with the rails and the angle between the antenna and wall is less than 1°. Do not incline the antenna towards the wall.
- If you customize mounting brackets, ensure that the distance between the central axis of the antenna and the installation wall is no less than 15 cm.
Wall Mounting
- Fix the mounting bracket to the wall, adjust the installation position using a level, and mark positions of four mounting holes.
- Use a hammer drill to drill holes at the four marked positions. Screw the nut into the expansion bolt, hammer the expansion bolt into a hole until the flat washer is closely attached to the wall. Remove the nut, spring washer, and flat washer in order.
- Fix the antenna onto the mounting bracket, fit flat washers, spring washers, and nuts in order, and tighten the nuts (the tightening torque is 5 N m). Stretch the feeder port out of the hole of the mounting bracket.
- Pinch the mounting bracket on the expansion bolts, fit flat washers, spring washers, and nuts in order, and tighten the nuts (the tightening torque is 5 N m).
