Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Pole Mounting
The 27012566 antenna can be mounted on a pole. The wall thickness of the pole should be no less than 2.5 mm. A 50 mm diameter pole made of round steel is usually used.
- The antenna must be installed in a place far away from high-voltage power supplies or radio signal interference sources (such as other APs or antennas).
- Do not install antennas in bad weather conditions, for example, during rain, snow, or strong winds.
- Fix the installation bracket to the back of the antenna with the nuts, spring washers, and flat washers. The maximum torque is 6.2 N m.
- Fix the elevation adjustable bracket to the installation bracket.
Select appropriate holes and thread bolts through the installation bracket and elevation adjustable bracket. Put on flat washers, spring washers, and nuts to fix the bolts (not tightly).
- Fix the antenna support to the pole.
- Fix the antenna to the antenna support. Thread bolts through the antenna support and elevation adjustable bracket. Put on flat washers, spring washers, and nuts to fix the bolts (not tightly).
- Adjust the antenna angle and tighten all of the four nuts. The maximum torque is 6.2 N m.
