Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
27011172 Antenna Installation
27011172 antennas are directly installed on APs. You only need to tighten nuts.
The following figure shows the antenna installation.
- It is recommended that you connect a 50 ohm RF load to an idle antenna interface and wrap the RF load with both the insulation and waterproof tape.
- Wrap the connectors in single-layer PVC insulation tape, triple-layer waterproof tape, and then triple-layer PVC insulation tape.
- Before wrapping the waterproof tape, stretch the tape evenly until it is 1/2 the width as before. With each layer of tape wrap the cable tightly and ensure that each layer covers more than 50% of the layer beneath it.
- Wrap the triple-layer tape from bottom to top, from top to bottom, and then from bottom to top again.
- To achieve the optimal coverage effect, it is recommended that you install the omnidirectional antenna four to six meters above ground.
- When installing an antenna, tightly hold the antenna connector and tighten it using a torque wrench. The recommended tightening torque is 0.8 N·m to 1.0 N·m.
- Tighten the nut of the AP's RF connector with a torque of no more than 1.2 N·m.