27014279 Technical Specifications
Appearance and Structure
Technical Specifications
| Item | Details |
|---|---|
| Part Number | 27014279 |
| Model | ANTDG1115D4NM |
| Description | Directional Antenna,N -male,with bracket,2400~2500MHz&5150~5850MHz,4port, mining use |
| Frequency [MHz] | 2.4G: 2400-2500 5G: 5150-5850 |
| Antenna gain [dBi] | 2.4G: 11 5G: 15 |
| Horizontal beamwidth [degrees] | 2.4G: 30 5G: 15 |
| Vertical beamwidth [degrees] | 2.4G: 30 5G: 15 |
| Standing wave ratio (SWR) | ≤ 2.0 |
| Polarization | Horizontal and vertical polarization |
| Attenna connector | N-male x 4 (two 2.4 GHz RF ports + two 5 GHz RF ports) |
| Attenna dimensions [mm(in.)] | 45 mm x 450 mm x 240 mm (1.77 in. x 17.72 in. x 9.45 in.) |
| Weight without packaging [kg(lb)] | Antenna body (excluding cables): 2.7 kg (5.95 lb) Mounting bracket: 0.65 kg (1.43 lb) |
| Installation type | Pole |
| Grounding requirements | Same as the AP |
| Pole diameter [mm(in.)] | φ34 to φ50 |
| Attenna note | The gains and lobe widths are typical values, and the actual values are within a range. For specifications, see the corresponding data sheet. The coverage distance is a reference value in certain conditions. Plan an appropriate distance value according to Huawei planning experience, local standards, and onsite environments. There may be differences in the standards of different countries, so the mapping between antennas and APs shall comply with local standards. For details, refer to device access authentication information. The coverage distance is subject to the following constraints: - The default STA type is mobile phone, and no obstacle exists. - 2.4 GHz: The uplink and downlink RSSIs are greater than or equal to -75 dBm. - 5 GHz: The uplink and downlink RSSIs are greater than or equal to -75 dBm. For any questions about the parameters above, contact Huawei technical support. |
| Wind resistance | 36 m/s |
Antenna's Radiation Pattern
