Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting RF Cables
Procedure
- Remove covers on external antenna ports of APs to expose RP-SMA female connectors.
- Connect SMA male connectors of feeder cables to ANT ports on APs.
RF Cable Photos
Figure 28-5 RF cables
![]( "Click to enlarge")
Figure 28-6 Labels
![]( "Click to enlarge")
You can use the following RF transit cables.
Part Number |
Cable Length |
Interface Description |
|---|---|---|
04130532 |
5 m |
SMA-J/RP-SMA-J |
04130532-001 |
10 m |
|
04130532-002 |
15 m |
- Connectors on the two ends of an RF cable are different. You should connect the AP side connector to the AP and the antenna side connector to the antenna.
- The longer the feeder cable, the weaker the signal strength within the antenna coverage range. The cabling method in Figure 28-7 is recommended. The feeder cable should be as short as possible. The 15-meter feeder cable is not recommended.
In dual-band and double-stream scenarios, ensure that the two antenna ports with the same number on the AP9330DN are connected to the same antenna.