Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Wall Mounting
The 27012566 antenna can be mounted on a wall.
- The antenna must be installed in a place far away from high-voltage power supplies or radio signal interference sources (such as other APs or antennas).
- Do not install antennas in bad weather conditions, for example, during rain, snow, or strong winds.
- Fix the installation bracket to the back of the antenna with the nuts, spring washers, and flat washers. The maximum torque is 6.2 N m.
- Fix the elevation adjustable bracket to the installation bracket.
Select appropriate holes and thread bolts through the installation bracket and elevation adjustable bracket. Put on flat washers, spring washers, and nuts to fix the bolts (not tightly).
- Drill four φ10 mm holes (72 mm depth) on the wall to install plastic expansion tubes that will support expansion bolts. The relative position of the four holes must exactly match with that of the four holes on the antenna support.
- Fix the antenna support to the wall using expansion bolts.
- Fix the elevation adjustable bracket to the antenna support. Thread bolts through the installation bracket and elevation adjustable bracket. Put on flat washers, spring washers, and nuts to fix the bolts (not tightly).
- Adjust the antenna angle and tighten all of the four nuts. The maximum torque is 6.2 N m.
