No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

TP48200A-HT15D3 Outdoor Power System User Manual (Russia, Megafon)

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing the Heater

Replacing the Heater

Prerequisites

You have obtained an ESD wrist strap, ESD gloves, protective gloves, the cabinet door key, and tools.

Context

Disconnect the AC input circuit breaker for the heater, instead of the AC input to the power system.

Procedure

  1. Connect the ground cable for the ESD wrist strap, and put on the ESD wrist strap and ESD gloves.
  2. Record the positions of cables on the heater, and disconnect the cables.
  3. Remove the heater, as shown in Figure 4-21.

    Figure 4-21  Removing a heater

  4. Install a new heater.
  5. Reconnect the cables to the heater based on the recorded information.
  6. Disconnect the ground cable for the ESD wrist strap, and take off the ESD wrist strap and ESD gloves.
Download
Updated: 2019-03-05

Document ID: EDOC1000078967

Views: 7434

Downloads: 183

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next