No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


TP48200A-HT19C4-1, TBC300A-TCA2 Outdoor Power System User Manual

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Mechanical Safety

Mechanical Safety

Drilling Holes

Do not drill the cabinet at will. Drilling holes without complying with the requirements affects the electromagnetic shielding performance of the cabinet and damages the cables inside the cabinet. In addition, if the scraps caused by drilling enter the cabinet, the printed circuit boards (PCBs) may be short circuited.

  • Before you drill a hole in the cabinet, wear insulated gloves and remove the internal cables from the cabinet.
  • Wear an eye protector when drilling holes. This is to prevent your eyes from being injured by the splashing metal scraps.
  • Ensure that the scraps caused by drilling do not enter the cabinet.
  • Drilling holes without complying with the requirements affects the electromagnetic shielding performance of the cabinet.
  • After drilling, clean the metal scraps immediately.

Sharp Objects

Before you hold or carry a device, wear protective gloves to avoid getting injured by sharp edges of the device.

Handling Fans

When handling fans, note the following:
  • When replacing a component, place the component, screws, and tools in a safe place. Otherwise, if any of them fall into the operating fans, the fans may be damaged.
  • When replacing a component near fans, do not insert your fingers or boards into the operating fans until the fans are switched off and stops running.

Lifting Heavy Objects

When heavy objects are being lifted, do not stand or walk under the cantilever or the lifted object.

Updated: 2019-03-05

Document ID: EDOC1000078969

Views: 6666

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next