No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Can I Make a Device Show All the Information of a Command Output on One Screen

How Can I Make a Device Show All the Information of a Command Output on One Screen

If a command output is displayed in more lines than you can see on one screen, you can run the screen-length screen-length [ temporary ] command in the user view or user interface view to adjust the number of lines displayed on each screen of the terminal to facilitate viewing of the command output.

The value of screen-length is an integer that ranges from 0 to 512. If the value of screen-length is 0, the split screen function is disabled, that is, the system does not automatically pause until all information of the command output is displayed when the information cannot be completely displayed on one screen.

Table 29-40  Configuring one-screen display of terminal screen information

Login Mode

Procedure

Log in to the device through the console port.

Run the following commands to configure one-screen display of terminal screen information.

<Huawei> system-view
[Huawei] user-interface console 0
[Huawei-ui-console0] screen-length 0

Log in to the device through Telnet or SSH.

Run the following commands to configure one-screen display of terminal screen information.

<Huawei> system-view
[Huawei] user-interface vty 1 3
[Huawei-ui-vty1-3] screen-length 0
Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 446616

Downloads: 4301

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next