No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Configure DHCP Static Binding (Using the Web System)?

How Do I Configure DHCP Static Binding (Using the Web System)?

Procedure

  • Configure DHCP static binding on the web system of the EasyOperation edition.

    • After logging in to the web system of the EasyOperation edition, choose Advanced > IP > DHCP Address Pool. The DHCP Address Pool page is displayed.

    • Set Address pool type to Global address pool or Interface address pool, and select or enter parameters as required. Create a DHCP address pool, and configure static binding between IP addresses and MAC addresses. For configuration details, see Huawei AR100&AR120&AR150&AR160&AR200&AR1200&AR2200&AR3200&AR3600 Series Enterprise Routers Web-based Configuration-EasyOperation Edition-Advanced-IP-DHCP Address Pool.

  • Configure DHCP static binding on the web system of the Classics edition.

    • After logging in to the web system of the Classics edition, choose IP Service > DHCP > DHCP Configuration. The DHCP Configuration page is displayed.

    • In DHCP Service Information List(IPv4), click Create. In the Create DHCP Service dialog box that is displayed, set parameters as required, create DHCP service, and configure static binding between IP addresses and MAC addresses. For configuration details, see Huawei AR100&AR120&AR150&AR160&AR200&AR1200&AR2200&AR3200&AR3600 Series Enterprise Routers Web-based Configuration-Classics Edition-IP Services-DHCP-DHCP Configuration.

More Information

For details about configuring DHCP static binding through the CLI, see How Do I Configure DHCP Static Binding (Using the CLI)?

Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 448301

Downloads: 4305

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next