No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Can L2TP Be Used in Scenarios Where Active and Standby LNSs Are Deployed?

Can L2TP Be Used in Scenarios Where Active and Standby LNSs Are Deployed?

L2TP can be used in scenarios where active and standby LNSs are deployed. When the active LNS fails, services are switched to the standby LNS. However, L2TP connection requests initiated by the LAC cannot reach the active LNS. To ensure that L2TP connection requests are sent to the standby LNS, you must configure the IP address of the standby LNS on the LAC, so that when the first IP address is unreachable, the LAC sends the request packets to the address of the standby LNS.

You can configure IP addresses of a maximum of four LNSs on the LAC.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000079719

Views: 490224

Downloads: 4514

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next