No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Can I Do If an Interface Goes Up and Down Frequently After PPP Negotiation Succeeds?

What Can I Do If an Interface Goes Up and Down Frequently After PPP Negotiation Succeeds?

The cause of this is that Point-to-Point Protocol (PPP) link detection packets cannot be sent and received properly in excessive traffic.

To solve the problem, run the timer hold 0 command on the PPP service interface to prevent PPP from sending link detection packets.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000079719

Views: 494696

Downloads: 4527

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next