No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
After I Run the display fib Command, What Does Flag Mean in the Command Output?

After I Run the display fib Command, What Does Flag Mean in the Command Output?

Currently, Flag can have the following values:

  • B: a blackhole route, that is, a route with the outbound interface NULL0.

  • D: a route generated by a dynamic routing protocol such as Intermediate System to Intermediate System routing protocol (IS-IS), open shortest path first (OSPF), Border Gateway Protocol (BGP), or Routing Information Protocol (RIP).

  • G: a gateway route, that is, a route with a gateway as the destination address.

  • H: a host route.

  • S: a static route, that is, a route configured using the ip route-static command or configured on the network management system (NMS).

  • U: a route that is reachable.

Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 456457

Downloads: 4321

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next