No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Control Access Through Specific Source or Destination Addresses?

How Do I Control Access Through Specific Source or Destination Addresses?

You can configure access control lists (ACLs) to match source or destination addresses. For example, under the following configuration, the host at 10.1.1.1 can only access hosts on the 10.1.1.18/26 network segment.

<Huawei> system-view
[Huawei] acl 3000
[Huawei-acl-adv-3000] rule permit ip source 10.1.1.1 0 destination 10.1.1.18 0.0.0.63
[Huawei-acl-adv-3000] rule deny ip source 10.1.1.1 0

For configurations of other traffic classifiers, behaviors (actions set to permit), and policies, see Traffic Policy Configuration in the AR Configuration Guide - QoS.

Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 449125

Downloads: 4305

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next