No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Termination Sub-interfaces That Connect Two Devices Cannot Ping Each Other. Why?

Termination Sub-interfaces That Connect Two Devices Cannot Ping Each Other. Why?

After you configure IP addresses for termination sub-interfaces that connect two devices, they cannot ping each other. Check whether you have run the arp broadcast enable command on the interfaces. If this command is not run, the devices fail to send ARP Request packets through these interfaces and cannot learn ARP entries. By default, the arp broadcast enable command is disabled in V200R003C00 and earlier versions and enabled in V200R003C01 and later versions.

Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 448714

Downloads: 4305

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next