No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Which Interfaces Can I Configure a BFD Session On?

Which Interfaces Can I Configure a BFD Session On?

In V200R001C00, only Ethernet interfaces support BFD sessions.

In V200R001C01 and later versions, the following interfaces support common BFD sessions:
  • Physical interfaces: Layer 3 Ethernet interfaces, serial interfaces (including synchronous SA interfaces, E1/T1 interfaces, CE1/CT1/PRI interfaces, CE3 interfaces, and CPOS interfaces), POS interfaces, ATM interfaces (including ADSL interfaces, VDSL interfaces, E1-IMA interfaces, and G.SHDSL interfaces).

  • Logical interfaces: Ethernet sub-interfaces (including Dot1q sub-interfaces and QinQ sub-interfaces), dialer interfaces, VLANIF interfaces, Layer 3 Eth-Trunks, IP-Trunk interfaces, MP-Group interfaces, MFR interfaces, IMA-group interfaces, serial sub-interfaces, channelized serial sub-interfaces, IMA-group sub-interfaces, POS sub-interfaces, ATM sub-interfaces, MFR sub-interfaces, and Eth-Trunk sub-interfaces (Dot1q sub-interfaces).

    NOTE:

    When a physical Ethernet interface consists of multiple sub-interfaces, a BFD session can be established on the physical Ethernet interface or each sub-interface.

In V200R001C01 and later versions, the following interfaces support multicast BFD sessions:
  • Physical interfaces: Layer 2 and Layer 3 Ethernet interfaces

  • Logical interfaces: Layer 2 Eth-Trunks and Layer 3 Eth-Trunks

NOTE:
  • Multicast BFD sessions cannot be established on Layer 2 Ethernet interfaces, Layer 2 Eth-Trunks, or Layer 3 Eth-Trunks of AR100, AR120, AR150, AR160, AR200, and AR1200's SRUs.

  • Multicast BFD sessions cannot be established on Layer 2 Ethernet interfaces, Layer 2 Eth-Trunks, or Layer 3 Eth-Trunks of AR120-S, AR150-S, AR160-S, AR200-S, and AR1200-S's SRUs.

  • When a physical Ethernet interface consists of multiple sub-interfaces, a BFD session can be established on the physical Ethernet interface or each sub-interface.

Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 447861

Downloads: 4305

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next