No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Are the Rules for Selecting Routes Belonging to Different OSPF Processes?

What Are the Rules for Selecting Routes Belonging to Different OSPF Processes?

OSPF supports multi-processes. Multiple OSPF processes can run on the same router independently.

Assume that a router is configured with two OSPF processes: process 1 and process 2. They are independent of each other. Therefore, both of the routes belonging to process 1 and process 2 are advertised to the routing management (RM) module. Route selection between the two processes complies with the following rules:
  1. The RM module checks the protocol preference of process 1 and process 2. The route belonging to the process with higher protocol preference is selected as the optimal route.
    NOTE:

    To set the preference of an OSPF route in the specified process, run the preference [ ase ] { preference | route-policy route-policy-name } * command. The default preference of an OSPF route is 10. When an ASE is specified, the default value is 150.

  2. When the protocol preferences of the two processes are the same, the RM module compares the cost of the two routes. The route with smaller cost value is selected as the optimal route.
    NOTE:

    When selecting the optimal route, the RM module first compares the protocol preference. The RM module compares the cost of routes only when the protocol preferences are the same.

Translation
Download
Updated: 2019-08-09

Document ID: EDOC1000079719

Views: 490410

Downloads: 4514

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next