No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Rectify the Failure to View SA Information by Running the display ipsec sa Command After IPSec Is Configured?

How Do I Rectify the Failure to View SA Information by Running the display ipsec sa Command After IPSec Is Configured?

To rectify the failure, perform the following operations:

  1. Perform the ping operation to check the public network connectivity.

  2. If the IPSec tunnel is established through IKE negotiation, run the display ike sa command to check whether the IKE SA is successfully established.

  3. Wait about 10 seconds and run the display ipsec sa command again.

  4. Run the display interface brief command to verify that the interface bound to the IPSec policy is in the Up state.

  5. Verify that IPSec is configured correctly.

Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 450319

Downloads: 4307

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next