No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR Router Troubleshooting Guide

This Product Documentation provides guidance for maintaining AR Enterprise Router, covering common information collection and fault diagnostic commands, typical fault troubleshooting guide, and troubleshooting.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Configure or Delete the Read-Write Community Name of SNMPv1 or SNMPv2c?

How Do I Configure or Delete the Read-Write Community Name of SNMPv1 or SNMPv2c?

In the system view, you can run the snmp-agent community command to configure the read-write community name of SNMPv1 or SNMPv2c and run the undo snmp-agent community command to delete the community name. When running the snmp-agent community command, you can select parameters based on the networking requirements.
  • To grant only the read right to the NMS in the specified view (for example, for an administrator with a low level), use the read parameter.
  • To grant the read and write rights to the NMS in the specified view (for example, for an administrator with a high level), use the write parameter.
  • To allow some NMSs using a community name to access the MIB view Viewdefault, do not specify the mib-view view-name parameter.
  • To allow all NMSs using a community name to manage certain objects, do not specify the acl acl-number parameter.
  • To allow some NMSs using a community name to manage certain objects, specify both mib-view and acl parameters.
NOTE:
If both community name and ACL are configured, the device checks the community name and then the ACL before allowing the NMS to access it. If a community name does not exist, packets are discarded and the system prints a community name error log. In addition, the system does not check ACL. That is, the system checks ACL only when the community name exists.

To view the current community name, you can run the display snmp-agent community command.

Translation
Download
Updated: 2019-05-10

Document ID: EDOC1000079719

Views: 451316

Downloads: 4311

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next