No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Powering Off the Server

Powering Off the Server

Power off the server using the iBMC WebUI. After the power-off, all services and programs running on the server will stop running. Stop all services and programs or switch them to other servers before powering off the server. Before powering off the server, you need to obtain the IP address of the iBMC management network port, and the user name and password for logging in to the iBMC WebUI. For details about how to obtain the IP address for the management network port and how to operate the iBMC, see HUAWEI Rack Server iBMC User Guide.

Before powering off the server, ensure that server data has been saved and hard disk services have been stopped. Do not forcibly power off the server when read and write operations are being performed on hard disks. Otherwise, bad sectors may occur, compromising data sources.

The methods for powering off the server are as follows:

  • Hold down the power button to have the server enter the standby state.
    NOTE:

    When the power indicator is steady yellow, the server is in the standby state.

    • Connect the server to a video display, keyboard, and mouse using cables, and shut down the operating system.
    • Hold down the power button on the front panel until the server is powered off. For details about the power button position, see Appearance.
    • Log in to the Remote Virtual Console of the server, and shut down the operating system.

      For details about how to log in to the Remote Virtual Console, see Logging In to the Remote Virtual Console.

    • Power off the server using the iBMC WebUI. For details, see Powering Off the Server.
    • Power off the server using the iBMC CLI.

      Log in to the iBMC CLI. For details, see 9.3-Logging In to the iBMC CLI.

      Run the ipmcset -d powerstate -v 0 command on the iBMC CLI.

  • Power off the server completely.

    If the server has been powered off and is in the standby state, remove the power cable to disconnect the external power supply. After that, the server is powered off completely.

NOTE:

After powering off the server, wait at least 1 minute to ensure that the server is completely powered off. Then, you can power on the server again.

Procedure

Power off the server using the iBMC WebUI.

  1. Log in to the iBMC WebUI. For details, see Logging In to the iBMC WebUI.
  2. Choose Power > Power Control.

    The Power Control page is displayed, as shown in Figure 4-2.

    Figure 4-2 Power Control page

  3. Click Power Off. In the displayed dialog box, click Yes to power off the server.
Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 126210

Downloads: 2333

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next