No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Ports

Ports

Table 2-3 and Table 2-4 describe the external ports on the 5288 V3.

Table 2-3 Ports on the front panel

Port

Type

Quantity

Description

USB port

USB 2.0

2

The USB ports are connected to USB devices.

NOTE:

Before connecting to an external USB device, check that the USB device operates properly. A server may fail if it is connected to an abnormal USB device.

Table 2-4 Ports on the rear panel

Port

Type

Quantity

Description

VGA port

DB15

1

The VGA port is used to connect a terminal, such as a monitor or KVM.

USB port

USB 3.0

2

The USB ports are connected to USB devices.

NOTE:

Before connecting to an external USB device, check that the USB device operates properly. A server may fail if it is connected to an abnormal USB device.

USB 3.0 is disabled by default. You can enable it on the BIOS as required.

Management network port (Mgmt)

Ethernet port

1

The 1000 Mbit/s Ethernet port is used to manage the server.

Serial port

DB9

1

A three-pin serial port (that contains only the PIN2 RX, PIN3 TX, and PIN5 GND signals in the DB9 connector, no signals in other pins). The default baud rate is 115200 bit/s.

The serial port is used as the system serial port by default. You can set it as the iBMC serial port by using the iBMC command. The port is used for debugging.

Network port

-

-

The port types and quantity vary according to the configured flexible NIC.

Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 127094

Downloads: 2333

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next