No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Server over a Network Port Using PuTTY

Logging In to a Server over a Network Port Using PuTTY

Use PuTTY to remotely log in to a server over a local area network (LAN) and configure and maintain the server.

Ensure that the following requirements are met:

  • The local PC is connected to the management network port of the server through a network cable.
  • PuTTY is installed.

    You can download PuTTY from chiark website. You are advised to use the latest version of PuTTY, otherwise you may fail to log in to the server.

  • IP address of the server.
  • User name and password for logging in to the server.

Procedure

  1. Set an IP address and a subnet mask or add route information for the PC to communicate with the server.
  2. On the PC command-line interface (CLI), run the following command to check whether the server is reachable:

    Ping Server IP address

  3. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed, as shown in Figure 9-16.

    Figure 9-16 PuTTY Configuration window

  4. Set the login parameters.

    The parameters are described as follows:

    • Host Name (or IP address): Enter the server IP address of the server to be accessed, for example, 191.100.34.32.
    • Port: Retain the default value 22.
    • Connection type: Retain the default value SSH.
    • Close window on exit: Retain the default value Only on clean exit.
    NOTE:

    Configure Host Name (or IP address) and Saved Sessions, and click Save. You can double-click the saved record under Saved Sessions to log in to the server the next time.

  5. Click Open.

    The PuTTY window is displayed.

    NOTE:

    If this is your first login to the server, the PuTTY Security Alert dialog box is displayed. Click Yes to proceed.

  6. Enter the user name and password.

    NOTE:

    If an incorrect user name or password is entered, you must set up a new PuTTY session.

    If the login is successful, the server host name is displayed on the left of the prompt.

Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 127314

Downloads: 2333

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next