No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the Supercapacitor (Standard RAID Controller Card)

Installing the Supercapacitor (Standard RAID Controller Card)

Install a supercapacitor to replace the original one.

When LSI SAS3108 or PM8060 RAID controller cards are configured, supercapacitors can be configured to provide extra power.

Before installing a supercapacitor, power off the server. Pay attention to electrical safety.

Procedure

  1. Wear an ESD wrist strap. For details, see Safety Instructions.
  2. Remove the supercapacitor to be replaced. For details, see Removing the Supercapacitor (Standard RAID Controller Card).
  3. Take the supercapacitor out of its ESD bag.
  4. Place the supercapacitor downwards and exert even force to install it in the tray. Ensure that the supercapacitor is secured by the plastic latches. See step (1) in Figure 7-67 and Figure 7-68.
  5. Determine the position and chip model of the RAID controller card connected to the supercapacitor to be installed.

    If the chip model of the RAID controller card connected to the supercapacitor to be installed is LSI SAS3108, install the trans flash module (TFM) first.

    Figure 7-67 Installing the supercapacitor (LSI SAS3108)

    1. Insert the TFM vertically into the RAID controller card. See step (3) in Figure 7-67.
    2. Screw the TFM. See step (4) in Figure 7-67.
    3. Connect the cable between the supercapacitor and the TFM. See step (2) in Figure 7-67.
    NOTE:

    When installing the TFM, ensure that the side with pins on the connector faces the TFM to prevent damage of the device due to reverse insertion of the connector.

    If the chip model of the RAID controller card connected to the supercapacitor to be installed is PM8060:

    Figure 7-68 Installing the supercapacitor (PM8060)

    1. Connect the cable between the supercapacitor and the RAID controller card. See step (2) in Figure 7-68.

  6. Install the riser card tray above the RAID controller card. For details, see Removing the Riser Card.
  7. Install the chassis cover. For details, see Installing the Chassis Cover.
  8. Install the 5288 V3. For details, see Installing the Server.
  9. Connect all internal cables such as power and network cables. For details, see Connecting External Cables.
  10. Power on the 5288 V3. For details, see Powering On the Server.
Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 138461

Downloads: 2336

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next