No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting Cables to a Mouse, Keyboard, and VGA Port

Connecting Cables to a Mouse, Keyboard, and VGA Port

After powering on the server, connect cables to a mouse, keyboard, and VGA port to set the basic input/output system (BIOS) and RAID, and log in to the operating system (OS).

The front and rear panels of the server provide DB15 video graphics array (VGA) ports but have no standard PS/2 port for a keyboard or mouse. You can connect a keyboard and mouse to the USB ports on the front or rear panel based on site installation conditions. The following describe two connection methods:

  • Connect a keyboard and mouse to the USB ports.
  • Connect a keyboard and mouse by using a USB-to-PS/2 cable.

Procedure

  1. Connect the USB connector on the PS/2 cable to the USB port on the front or rear panel of the server.
  2. Connect the connectors on the other end of the PS/2 cable to the keyboard and mouse.
  3. Connect the DB15 connector on one end of a VGA cable to the VGA port on the rear panel of the server. Tighten the screws on both sides of the connector to secure the cable.
  4. Connect the other end of the VGA cable to the VGA port on the monitor. Tighten the two screws on the connector to secure the cable.

    Figure 3-21 Connecting a USB-to-PS/2 cable and a VGA cable

Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 127305

Downloads: 2333

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next