No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing an M.2 SATA SSD Card

Removing an M.2 SATA SSD Card

Remove an M.2 SATA SSD card before replacing it with a new one. An M.2 SSD riser card can be configured with two M.2 SATA SSD cards. The replacement method is the same for the two M.2 SATA SSD cards. An M.2 SATA SSD card using the external SATA1 port is used as an example in this topic.

Procedure

  1. Wear an ESD wrist strap. For details, see Safety Instructions.
  2. Determine the rack number and chassis number of the server to be removed, and label its panel to prevent misoperations.
  3. Power off the 5288 V3. For details, see Powering Off the Server.
  4. Remove all external cables such as power and network cables.
  5. Remove the 5288 V3 and put it on an ESD desktop. For details, see Removing the Server.
  6. Remove the chassis cover. For details, see Removing the Chassis Cover.
  7. Remove the cables from the M.2 SSD riser card. For details, see M.2 SSD Riser Card Cabling in Internal Cabling.
  8. Remove the M.2 SSD riser card.

  9. Loosen the screw on the M.2 SATA SSD card using an M3 Phillips screwdriver. See step (1) in Figure 7-124.

    Figure 7-124 Removing an M.2 SATA SSD card

  10. Lift the screw end of the M.2 SATA SSD card upwards and pull it out at a 20° to 30° angle. See step (2) in Figure 7-124.
  11. Place the removed M.2 SATA SSD card in an ESD bag.
Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 140623

Downloads: 2336

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next