No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing an SD Card Board

Removing an SD Card Board

Remove a SD card board before replacing it with a new one.

Procedure

  1. Wear an ESD wrist strap. For details, see Safety Instructions.
  2. Determine the cabinet number and chassis number of the server, and label its panel to prevent misoperations.
  3. Power off the RH1288 V3. For details, see Powering Off the Server.
  4. Remove all external cables, such as power cables and network cables.
  5. Remove the RH1288 V3 and place the removed RH1288 V3 on the ESD desktop. For details, see Removing the Server.
  6. Remove the chassis cover. For details, see Removing the Chassis Cover.
  7. Loosen the two screws. See step (1) in Figure 7-104.

    Figure 7-104 Removing an SD card board

  8. Lift the SD card board till its connector is disconnected from the mainboard. See step (2) in Figure 7-104.
  9. Remove the SD card from the SD card board. For details, see Removing an SD Card.

    NOTE:

    SD card 1 is above the SD card board, and SD card 2 is below the SD card board.

  10. Place the removed SD card board in an ESD bag.
Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 137893

Downloads: 2336

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next