No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

5288 V3 Server V100R003 User Guide 26

This document describes the features, appearance, and technical specifications of the 5288 V3 server, and how to install, power on, and power off the 5288 V3 server, connect cables, and install an operating system (OS) for it.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Hard Disk

Installing a Hard Disk

Install a hard disk to replace the original one or add a new hard disk.

You do not need to power off the 5288 V3 before installing a hard disk.

After a failed hard drive is disconnected from the hard drive backplane, wait for 30 seconds before removing it and inserting a new one. The alarm persists after a new hard drive is installed and will be cleared after the RAID array is rebuilt. Do not frequently hot-swap a hard drive to prevent new alarms.

Procedure

  1. Wear an ESD wrist strap. For details, see Safety Instructions.
  2. Remove the hard disk to be replaced. For details, see Removing a Hard Disk.
  3. Take the spare hard disk out of its ESD bag.
  4. Fully raise the ejector lever and push the hard disk into the chassis along the guide rails until it does not move. See step (1) in Figure 7-12.

    Figure 7-12 Installing a hard disk

  5. Ensure that the ejector lever is fastened to the chassis beam, and lower the ejector lever to completely insert the hard disk into the chassis. See step (2) in Figure 7-12.

    Observe the hard disk indicators to check the hard disk operating status. For details about the indicators, see Indicators and Buttons.

  6. If a front hard disk is installed and the bezel is required, install the bezel. For details, see (Optional) Installing the Front Bezel.
  7. After verifying hard disk status, configure RAID properties based on actual service requirements. For details, see the HUAWEI V2&V3 Server RAID Controller Card User Guide.
Translation
Download
Updated: 2018-11-26

Document ID: EDOC1000080031

Views: 126180

Downloads: 2333

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next