No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI X6000 Server Upgrade Guide (iBMC) 05

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Performing the Upgrade

Performing the Upgrade

Scenarios

Upgrade the iBMC.

The following uses iBMC 2.50 as an example. The Upgrade Firmware page may vary according to iBMC versions.

NOTE:
  • The system user name and password remain unchanged after the upgrade.
  • The active and standby images of the iBMC must be upgraded separately.
  • Upgrade the standby image first. After the standby image is upgraded, restart the iBMC and upgrade the original active image.

Impact on the System

Upgrading the iBMC will cause the iBMC system to restart twice. Perform the upgrade during the off-peak hours.

Prerequisites

Conditions

  • You have logged in to the iBMC WebUI. For details, see Logging In to the iBMC WebUI.
  • No minor alarm, major alarm, or critical alarm is generated on the iBMC.

Data

Data preparation is not required for this operation.

Software

You have obtained image.hpm. For details, see Obtaining the Upgrade Packages and Documents.

Procedure

  1. Upgrade the standby iBMC image.

    NOTICE:

    If the iBMC version is earlier than 2.56, restart the iBMC before upgrading the firmware. To restart the iBMC, do as follows:

    • Log in to the iBMC WebUI, choose System > Firmware Upgrade, and click Restart iBMC in the Firmware Version Info area. For details about how to log in to the iBMC WebUI, see Logging In to the iBMC WebUI.
    • Log in to the iBMC CLI and run the ipmcset -d reset command to restart the iBMC. For details about how to log in to the iBMC CLI, see Accessing the iBMC CLI.
    1. Choose System on the main menu, as indicated by (1) in Figure 4-1.
    2. In the navigation tree, choose Upgrade Firmware, as indicated by (2) in Figure 4-1.
      Figure 4-1 Upgrade Firmware page
    3. In the Upgrade Firmware area, click , as indicated by (3) in Figure 4-1.

      The Browse window is displayed.

    4. Select image.hpm from a local folder.
    5. Click Open.

      The upgrade package is selected, and the Upgrade Firmware page is displayed.

    6. Click Upgrade, as indicated by (4) in Figure 4-1.

      The Start Upgrade dialog box is displayed.

    7. Click OK.

      The iBMC then starts the upgrade.

      Upgrade of the standby iBMC image takes about 5 to 10 minutes.

      The upgrade is complete when the progress reaches 100%.

      NOTE:

      After the upgrade is complete, the iBMC automatically restarts.

  2. Upgrade the original active iBMC image.

    1. Log in to the iBMC WebUI again.

      For details, see Logging In to the iBMC WebUI.

    2. Repeat Step 1 to upgrade the original active iBMC image.

Translation
Download
Updated: 2018-08-02

Document ID: EDOC1000081650

Views: 12287

Downloads: 134

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next