No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI X6000 Server Upgrade Guide (iBMC) 05

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Server Over a Network Port by Using PuTTY

Logging In to the Server Over a Network Port by Using PuTTY

Scenarios

You can use PuTTY to remotely log in to the server over a local area network (LAN) and to configure and maintain the server.

Prerequisites

Conditions

The PC is connected to the management network port of the server using a network cable.

Data

  • IP address of the server
  • User name and password for logging in to the server

Software

PuTTy.exe

Procedure

  1. Set an IP address and a subnet mask or add route information for the PC, and ensure that the PC can properly communicate with the server.

    You can run the Ping Server IP address command in the command window of the PC to check the communication between the PC and the server.

  2. Double-click PuTTY.exe.

    The PuTTY Configuration window is displayed, as shown in Figure A-18.

    Figure 9-18 PuTTY Configuration window
  3. Set login parameters.
    • Host Name (or IP address): Enter the IP address of the server, for example, 192.168.2.1.
    • Port: Use the default value 22.
    • Connection type: Use the default value SSH.
    • Close window on exit: Use the default value Only on clean exit.
    NOTE:

    Configure Host Name and Saved Sessions, and click Save. In future use, you can directly double-click a saved record to log in to the server.

  4. Click Open.

    The PuTTY window is displayed.

    NOTE:

    If it is your first login, the PuTTY Security Alert window is displayed. Click Yes. Then the PuTTY window is displayed.

  5. Enter the user name and password after login as:
    NOTE:

    If the entered user name is incorrect during server login, the PuTTY must be connected to again.

    If the login is successful, the server host name is displayed on the left of the prompt.

Translation
Download
Updated: 2018-08-02

Document ID: EDOC1000081650

Views: 11591

Downloads: 134

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next