No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

HUAWEI X6000 Server Upgrade Guide (iBMC) 05

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Management Module CLI Through the Management Network Port

Logging In to the Management Module CLI Through the Management Network Port

Scenarios

Log in to the management module CLI through the management network port.

Prerequisites

Conditions

The server has been powered on.

Data

  • IP address of the management module management network port
  • User name and password for logging in to the management module

Software

PuTTY.exe (third-party software)

Procedure

  1. Connect the client to the management network port.

    1. Connect the client to the management network port on the management module using a network cable, as shown in Figure A-20 or Figure A-21.
      Figure 9-20 Connecting the client to the management network port (X6000 V3)
      Figure 9-21 Connecting the client to the management network port (X6000 V5)

  2. Set the client address.

    1. Set the IP address, subnet mask, or route of the client to enable the client to interconnect with the management network port.

      On the client, choose Start > Run, enter cmd, and click OK. Then, run the Ping IP address of the aggregated management network port command to check whether the management network port is reachable.

  3. Log in to the management module CLI.

    1. On the client, double-click PuTTY.exe.

      The PuTTY Configuration window is displayed, as shown in Figure A-22.

      Figure 9-22 PuTTY Configuration
    2. Set the login parameters.
      The parameters are described as follows:
      • Host Name (or IP address): Enter the IP address of the management network port, for example, 192.168.2.1.
      • Port: Retain the default value 22.
      • Connection type: Retain the default value SSH.
      • Close window on exit: Retain the default value Only on clean exit.
      NOTE:

      After you set Host Name (or IP address) and then Saved Sessions and click Save, you can simply double-click the saved settings under Saved Sessions to log in to the server.

    3. Click Open.

      The PuTTY window is displayed. Then the message login as: is displayed, prompting you to enter a user name.

      NOTE:
      • If you log in to the server for the first time, the PuTTY Security Alert dialog box is displayed. If you trust this site, click Yes. The PuTTY window is displayed.
      • If the entered user name or password is incorrect during server login, PuTTY must be connected again.
    4. Enter the user name and password as prompted.

      After login, the host name of the device is displayed on the left of the prompt.

Translation
Download
Updated: 2018-08-02

Document ID: EDOC1000081650

Views: 11518

Downloads: 134

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next