No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference 10

OceanStor 18500 V3 and 18800 V3 Mission Critical Storage System V300R003

"Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change svp management_ip

change svp management_ip


The change svp management_ip command is used to configure the IP address of a management port on SVP. Both an IPv4 and IPv6 address can be configured, which is used by terminals to access the disk array.


change svp management_ip eth_port_id=? ip_type=? [ ipv4_address=? mask=? gateway_ipv4=? ] [ ipv6_address=? prefix_length=? gateway_ipv6=? ]





eth_port_id=? Indicates the port ID.

To obtain the value, run "show system management_ip".

ip_type=? Indicates the IP address type.

The value can be an IPv4 or IPv6 address.

IPv4_address=? Indicates the IPv4 address.

IPv4 address can not begin with 0.

mask=? Indicates the IPv4 subnet mask of the management port.


gateway_ipv4=? Indicates the configured IPv4 gateway.


ipv6_address=? Indicates the configured IPv6 address of the management port.


prefix_length=? Indicates the configured IPv6 subnet mask.


gateway_ipv6=? Indicates the configured IPv6 gateway of the management port.




Usage Guidelines

  • When the maintenance terminal and the storage system are not in the same network segment, the terminal cannot access the storage system. You have to add a router to the maintenance terminal and a gateway to the storage system so that the maintenance terminal can access the storage system.
  • Before performing the operation, ensure that the address you entered is valid and the IPv4 address must not start with 0.
  • Changing the IP address of the management port may disconnect a user that has logged in from the storage system, so log in to the storage system again after changing the IP address.
  • The maintenance terminal can access the storage system both through an IPv4 and IPv6 address.


Set the IPv4 address of a specified management network port to, the subnet mask to, and the gateway address to, run the following command. The command output varies depending on a specific product.

admin:/>change svp management_ip eth_port_id=P1 ip_type=ipv4_address ipv4_address= mask= gateway_ipv4=
DANGER: You are about to modify the IP address of the management network port on the SVP. This operation may disconnect you from the SVP. 
Suggestion: Ensure that the entered IP address is available. 
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)

System Response


Updated: 2019-07-22

Document ID: EDOC1000084078

Views: 317601

Downloads: 253

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next