No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Parts Replacement 12

OceanStor 18500 V3 and 18800 V3 Mission Critical Storage System V300R003

This document describes the procedure for replacing the parts of storage system in terms of safety operations, preparations, and precautions.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing the SVP

Installing the SVP

This section describes how to install the SVP.

Prerequisites

  • A spare SVP for replacement is ready.
  • The cable connection position on the SVP to be replaced has been clearly marked.

Tools and Materials

  • ESD wrist strap or ESD gloves.
  • Flat-head screwdriver.

Procedure

  1. Install the SVP.
    1. At least two persons lift the SVP on two sides and move it to the rack.
    2. Place the SVP on the guide rails and push it into the rack, as shown in Figure 7-14.

      Figure 7-14  Installing the SVP

    3. When the two mounting ears on the SVP contact the mounting bars on the rack, tighten the captive screws on the mounting ears to secure the SVP.
  2. Connect the cables and power on the SVP.
  3. Set the IP address of a management network port on the SVP. For details, see Installation Guide.
  4. Ensure that the SVP version is consistent with the engine version of the storage system.
    1. Start PuTTY on the SVP and use the IP address of the management network port to log in to the engine.
    2. Run the show upgrade package command to obtain the engine version.
    3. In Windows, go to the D:\huawei directory, open the version file with Notepad, and check whether the SVP version is consistent with the engine version in the first line.

      • If yes, go to 5.
      • If no, go to 4.d.

    4. For details about the SVP version, see Upgrade Guide.
  5. Optional: Set the GSM modem. For details, see Installation Guide.
  6. Activate the antivirus software. For details, see Installation Guide.

    NOTE:
    You can also use the license that you have applied for to activate the antivirus software.

Translation
Download
Updated: 2019-05-15

Document ID: EDOC1000084105

Views: 21257

Downloads: 140

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next