No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Parts Replacement 12

OceanStor 18500 V3 and 18800 V3 Mission Critical Storage System V300R003

This document describes the procedure for replacing the parts of storage system in terms of safety operations, preparations, and precautions.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Fan Module

Replacing a Fan Module

This section describes how to replace a fan module.

Impact on the System

During the replacement of a fan module, the system's heat dissipation is affected, degrading the system reliability.

Prerequisites

  • The replacement fan module is ready.
  • The fan module that you want to replace has been located.

Precaution

  • Do not touch rotating fan blades.
  • Remove and insert a fan module with even force. Excessive force may damage the connectors or appearance of the fan module.
  • Remove only one fan module at a time.
  • After removing a fan module, install a new one within two minutes. Otherwise, the system heat dissipation is compromised.

Tools and Materials

  • ESD wrist strap
  • ESD bag
  • Label

Procedure

  1. Wear an ESD wrist strap.
  2. Press the latch on the fan module and pull out the fan module, as shown in Figure 6-4.

    Figure 6-4  Removing a fan module

  3. Put the removed fan module into an ESD bag.
  4. Take the replacement fan module out of its ESD bag.
  5. Insert the replacement fan module into the empty slot until it clicks into place, as shown in Figure 6-5.

    Figure 6-5  Installing a fan module

  6. Wait about one minute and check the status of the Running/Alarm indicator on the fan module to determine whether the fan module is successfully installed. Figure 6-6 shows the location of the Running/Alarm indicator on the fan module.

    • If the indicator is steady green, the fan module is successfully installed.
    • If the indicator is steady red or off, the newly installed fan module is faulty, the fan module slot is faulty, or the fan module is incorrectly installed.
    Figure 6-6  Running/Alarm indicator on a fan module

Follow-up Procedure

Label the replaced fan module to facilitate subsequent operations.

Translation
Download
Updated: 2019-05-15

Document ID: EDOC1000084105

Views: 20967

Downloads: 140

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next