No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference 10

OceanStor 5300 V3, 5500 V3, 5600 V3, 5800 V3, and 6800 V3 Storage System V300R003

"Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change fs_snapshot restore

change fs_snapshot restore


The change fs_snapshot restore command is used to roll a file system to a specific snapshot.


change fs_snapshot restore snapshot_id=?





snapshot_id=? Indicates the ID of the snapshot the file system rolls back to.

To obtain the value, run "show fs_snapshot general".



Usage Guidelines

Before running this command, check whether the ID of the snapshot is correct.


To roll the file system to snapshot "0@snap1", run the following command:

admin:/>change fs_snapshot restore snapshot_id=0@snap1
DANGER: You are about to run a command to roll back a read-only file system snapshot. Data in the corresponding file system will be rolled back to the state preserved by the specified snapshot. In addition, the mount point of the file system may become invalid, all the read-only snapshots generated after the specified read-only snapshot will be deleted.
Before running this command:
1. Umount the file system on the host.
2. Ensure that the file system snapshot you have selected is correct.
Have you read danger alert message carefully?<y/n>y
Are you sure you really want to perform the operation?<y/n>y
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000084195

Views: 368566

Downloads: 1594

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next