No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference 10

OceanStor 5300 V3, 5500 V3, 5600 V3, 5800 V3, and 6800 V3 Storage System V300R003

"Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change port eth

change port eth


The change port eth command is used to configure the maximum transmission unit (MTU) of Ethernet ports (including host ports and management network ports).


change port eth eth_port_id=? mtu=? [ is_host_port=? ]





eth_port_id=? ID of a port.

To obtain the value, run "show port general".

mtu=? Size of the largest packet that can be transmitted on a certain layer of a protocol.

The value ranges from 1280 to 9000, expressed in bytes.

is_host_port=? Whether the port is a host port. This parameter is valid for a S2600T only. When the value is set to "yes", you can set the management port H4 or the maintenance port H5 as a host port.

The value can be "on" or "off", where:

  • "yes": The port is a host port.
  • "no": The port is not a host port.
The default value is "no".



Usage Guidelines



Set the MTU of the Ethernet port whose ID is "ENG0.A1.P0" to "1600". The ID and output vary depending on a specific product.

admin:/>change port eth eth_port_id=ENG0.A1.P0 mtu=1600
DANGER: You are about to modify the MTU of the Ethernet port.
This operation may interrupt services or cause service exceptions.
Suggestion: Before performing this operation, determine whether the modification is necessary.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000084195

Views: 365591

Downloads: 1594

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next