No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference 10

OceanStor 5300 V3, 5500 V3, 5600 V3, 5800 V3, and 6800 V3 Storage System V300R003

"Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
remove port ipv4_route

remove port ipv4_route


The remove port ipv4_route command is used to delete an IPv4 route configured for a specific iSCSI host port.


remove port ipv4_route eth_port_id=? target_ip=? mask=? gateway=?





eth_port_id=? ID of a port.

To obtain the value, run "show port general".

target_ip=? Address of the IPv4 network segment where a host resides.

The value must be an IPv4 address.

mask=? IPv4 subnet mask of a host.

The value must be an IPv4 subnet mask.

gateway=? IPv4 gateway address of an iSCSI host port.

The value must be an IPv4 address.



Usage Guidelines

Before performing this command, ensure that the port has an IPv4 route.


Delete an IPv4 route configured for the iSCSI host port whose ID is "ENG0.A3.P0", where the target network segment address is "". The ID and output vary depending on a specific product.

admin:/>remove port ipv4_route eth_port_id=ENG0.A3.P0 target_ip= mask= gateway=
DANGER: You are about to remove the route of host port.
This operation will interrupt the connection between the storage system and host.
Suggestion: Before you perform this operation, ensure that you have stopped the business on the route.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000084195

Views: 368183

Downloads: 1594

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next