No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference 10

OceanStor 5300 V3, 5500 V3, 5600 V3, 5800 V3, and 6800 V3 Storage System V300R003

"Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change ntp_server config

change ntp_server config

Function

The change ntp_server config command is used to configure the time synchronization function. Run this command if you want the storage system to synchronize its time with that of an NTP server.

Format

change ntp_server config { enabled=? | ntp_interval=? ntp_unit=? } *

Parameters

Parameter

Description

Value

enabled=? Whether to enable the time synchronization function.

The value can be "yes" or "no", where:

  • "yes": enables NTP time synchronization.
  • "no": disables NTP time synchronization.
ntp_interval=? Synchronization period.

-

ntp_unit=? Unit of synchronization period.

The value can be "day", "hour", "minute" or "second", where:

  • day: The synchronization period is expressed in days.
  • hour: The synchronization period is expressed in hours.
  • minute: The synchronization period is expressed in minutes.
  • second: The synchronization period is expressed in seconds.

Level

Super administrator

Usage Guidelines

  • The time synchronization function can be enabled only when the value of the enabled=? parameter is yes and an NTP server is added.
  • If you configure NTP for the first time, run the add ntp_server general command to add an NTP server. Then run the change ntp_server config enabled=? ntp_interval=? ntp_unit=? Command to enable the time synchronization function and configure an automatic synchronization period.
  • If two NTP servers are configured for a system, ensure that the time of the two NTP server are consistent.

Example

Enabling the time synchronization function and setting the synchronization period to 24 hours.

admin:/>change ntp_server config enabled=yes ntp_interval=24 ntp_unit=hour
WARNING: You are about to change the system network time protocol (NTP) configuration.This operation may affect system licenses, alarms, and SystemReporter.
Suggestion: Make sure that you want to change the system NTP configuration before performing the operation.
Have you read warning message carefully?(y/n)y
Are you sure you really want to perform the operaton?(y/n)y
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-07-22

Document ID: EDOC1000084195

Views: 349352

Downloads: 1583

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next