No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference 10

OceanStor 5300 V3, 5500 V3, 5600 V3, 5800 V3, and 6800 V3 Storage System V300R003

"Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions."
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create bond_port

create bond_port

Function

The create bond_port command is used to create an Ethernet bond port. By binding multiple Ethernet ports, you can increase the data transmission bandwidth in parallel mode.

Format

create bond_port iscsi_port_id_list=? [ name=? ]

Parameters

Parameter

Description

Value

iscsi_port_id_list=? List of port IDs that you want to bind.
  • To obtain the value, run "show port general".
  • Separate the port IDs that you want to bind with commas (,).
name=? Name of the Ethernet bond port that you want to create.

The value contains 1 to 31 ASCII characters including digits, letters, underscores (_), hyphens (-), and periods (.).

Level

Administrator

Usage Guidelines

  • Running this command interrupts the connections of all Ethernet ports involved in the port bonding. In addition, these Ethernet ports' IP addresses and route settings will be lost, and the bond port will be used to carry services.
  • Before running this command, stop services carried by all Ethernet ports.
  • An Ethernet port can be added to one bond port only.

Example

Create an Ethernet bond port. The IDs of the ports to be bound are "ENG0.B1.P0" and "ENG0.B1.P1", and the name of the bond port is "newbond". The ID and output vary depending on a specific product.

admin:/>create bond_port iscsi_port_id_list=ENG0.B1.P0,ENG0.B1.P1 name=newbond
DANGER:You are about to bond Ethernet ports.
This operation will disconnect all links to the Ethernet port, and the IP address and route configurations will be lost. Services are switched to the newly bonded port. The mode of all switch ports connected to the Ethernet port must be configured to 802.3AD LACP.
Suggestion:
1. Before performing this operation, stop all services on the Ethernet port.
2. Configure the mode of all switch ports connected to the Ethernet port to 802.3AD LACP.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-04-04

Document ID: EDOC1000084195

Views: 273708

Downloads: 1557

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next