No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CH225 V3 Compute Node V100R001 User Guide 07

This document describes the appearance, functions, and structure of the CH225 V3 storage expansion compute node (CH225 V3 for short), and methods of installing, removing, and configuring the CH225 V3.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing the Supercapacitor

Removing the Supercapacitor

This section describes the precautions and procedure for removing the supercapacitor from a CH225 V3.

Scenarios

Remove a supercapacitor in any of the following scenarios:

  • A supercapacitor fails and is to be replaced.
  • A supercapacitor is low in power.
NOTE:

You need to replace the trans flash module (TFM) along with a supercapacitor when replacing the supercapacitor.

Figure 8-48 shows the position of the supercapacitor.

Figure 8-48 Position of the supercapacitor

Prerequisites

Conditions

Data

Data preparation is not required for this operation.

Tools

  • Electrostatic discharge (ESD) gloves.
  • M3 Phillips screwdriver.
  • Packaging materials, for example, an ESD bag.

Procedure

  1. Remove the supercapacitor's 6-pin cable from the RAID controller card. See step (1) in Figure 8-49.
  2. Press the plastic latches and push the supercapacitor out of the supercapacitor box horizontally. See steps (2) and (3) in Figure 8-49.

    Figure 8-49 Removing a supercapacitor

  3. Place the removed supercapacitor in an ESD bag.
  4. Use a Phillips screwdriver to remove the screws that secure the supercapacitor box, and lift the supercapacitor box upwards. See steps (1) and (2) in Figure 8-50.

    Figure 8-50 Removing a supercapacitor box

  5. Remove the RAID controller card from the mainboard by lifting it upwards. See Figure 8-51.

    Figure 8-51 Removing the mezzanine cards

  6. Use a Phillips screwdriver and remove the screws that secure the TFM, and remove the TFM by lifting it upwards Figure 8-52.

    Figure 8-52 Removing a TFM

  7. Place the removed TFM in an ESD bag.
  8. (Optional) If the supercapacitor does not need to be installed immediately, use screws to secure the RAID controller card. See Figure 8-53.

    Figure 8-53 Using screws to secure the RAID controller card

Translation
Download
Updated: 2019-07-10

Document ID: EDOC1000095351

Views: 7908

Downloads: 74

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next